ALKEN EVEN-FLO® 910E
Effective Date: 08/04/2006
Manufacturer's Name: Alken-Murray Corporation | |
Manufacturer's Address: P.O. Box 400, New Hyde Park, New York 11040 | |
T: 540-636-1236 Fax: 540-636-1770 | |
E-mail: msds@alken-murray.com | |
Manufacturer's Cage Code: 2A384 | |
For chemical emergency - spill, leak, fire or accident - call CHEMTREC - day or night - (800) 424-9300 or outside the USA (703) 527-3887 |
NFPA Hazard Ratings: |
Synonyms: | None |
CAS Number: | Not applicable to mixtures |
Chemical Formula: | mixture |
Formula ID Codes: | 910.1 |
Chemical Name | CAS Number | OSHA PEL | ACGIH TLV | % Weight |
Distillates (petroleum) intermediate catalytic cracked | ||||
Naphthalene | ||||
Non-ionic surfactant | ||||
Aliphatic & cyclic amines |
Emergency Overview: Caution: Eye and respiratory irritant. Potential Health Effects: |
|
|
Flash Point: 218 degrees F (103.3 degrees C) by PMCC Flammability Limits: NDA Autoignition temp: NDA Fire Extinguishing Media: Foam, water fog, carbon dioxide, dry chemical Special Fire-Fighting Information: Wear NIOSH-approved SCNAone. Use water spray to ool containers. Unusual Fire and Explosion Hazards: Vapors are heavier than air and may travel along the ground. |
Contain spill. Recover for possible reuse, or transfer to a possible container for disposal.. Use absorbent to clean up. Wash down spill area with soap and water. |
Store in cool dry place. Keep container closed when not in use. |
|
|
|
|
|
RCRA Hazard Class (if discarded): NDA. Wash containers down with water and disinfect with a 1% sodium hypochlorite solution before disposal in accordance with local, state and federal regulations for heating fuel. |
|
..................................Section 302/304 Extremely Hazardous Substances: None ..................................Section 311 Hazard Categorization: Acute health, chronic, delayed Health ..................................Section 313 Toxic Chemicals: None
|
16. Other Information Reason for Revision: CHEMTREC emergency contacts and centigrade flash point added. Alken-Murray Corporation provides the information contained herein in good faith, in compliance with the Occupational Safety and Health Act of 1970, but makes no representation as to its comprehensiveness or accuracy. This document is intended only as a guide to the appropriate precautionary handling of the material by a properly trained person using this product. Alken-Murray warrants that this product is of merchantable quality. The implied warranty of fitness for a particular purpose is limited to the extent the products are used for the purpose or uses described on the product's label or in any written instructions or materials distributed to the buyer by Alken-Murray and is hereby disclaimed should buyer use the products in a manner inconsistent with this uses or purposes described therein. In no event shall Alken-Murray be liable for any consequential, exemplary, or incidental damages incurred by buyer even if it has been advised of the possibility of such damages. |