HMIS & NFPA Hazard Ratings:

0=Minimal, 1=Slight, 2=Moderate, 3=Serious, 4=Severe

Hazard Symbol: C

 1. Product Identification

 2. Composition/Information on Ingredients

Ingredients not precisely identified are proprietary and/or non-hazardous per 29 CFR 1910-1200 and/or represent less than 1%. All chemical ingredients appear on the EPA TSCA inventory.

• Signs and Symptoms of Acute Overexposure: Irritating to eyes, skin, respiratoruy tract and digestive system.
• Signs and Symptoms of Chronic overexposure: Chronic inhalation and ingestion may cause effects similar to those of acute inhalation and ingestion.
• Medical Conditions Generally Aggravated by Exposure: None known.

• Inhalation: Remove patient to fresh air. Get prompt medical attention.
• Ingestion: Do not induce vomiting. Allow patient to rinse mouth with and give patient large amounts of fruit juice or water to drink. Get patient to hospital promptly.
• Skin Contact: Remove contaminated clothing and footwear. Wash skin with soap and water. Wash clothing before reuse. Get medical attention if skin is burned or if irritation persists.
• Eye Contact: Immediately flush eyes with water for 15 minutes, occasionally lifting the upper and lower eyelids. If irritation develops, get medical attention.
• Note to Physician: Treat symptomatically and supportively. There is no specific antidote.

Flash Point: None found by PMCC test method.

Flammability Limits: NDA

Fire Extinguishing Media: Water fog, chemical foam or alcohol-resistant foam.

Special Fire-Fighting Information: Wear NIOSH-approved SCNA. Use water spray to cool containers and to knock down fumes.

Unusual Fire and Explosion Hazards: Noxious amine vapor may be released in fire.

• Ventilation System: Good general ventilation is advisable. Local exhaust ventilation to decrease airborne concentration below permissible exposure limits.
• Personal Respirators (NIOSH or EN 149 Approved): Not required for normal use. Wear an approved self-contained unit with full-facepiece airline respirator in the positive pressure mode with emergency escape provisions.
• Skin Protection: Rubber gloves, boots and apron. Body covering clothing
• Eye Protection: Chemical safety goggles, full face shield
• Other Control Measures: None
• Exposure Limits: NDA

• Appearance and Color: Colorless or pale yellow liquid.
• Odor: Alcoholic-ammonia odor
• Solubility in Water: Miscible
• Specific Gravity: 0.98
• pH: 11.8
• % volatile by volume @ 21C (70F): NDA
• Boiling Point: 212 degrees F
• Melting Point: NDA
• Vapor Density (Air=1): NDA
• Vapor Pressure (mm Hg): NDA
• Evaporation Rate (Bu. Acetate=1): =Water

• Stability: Product is stable.
• Hazardous Decomposition Products: Nitrogen oxides, carbon monoxide, carbon dioxide, amines, ammonia.
• Hazardous Polymerization: has not been reported.
• Incompatibility: : Copper, brass, aluminum, acids, oxidizing agents, chlorine, hypochlorite, nitric acid
• Conditions to Avoid: Incompatibile chemicals, ignition sources, excess heat.

• Toxicological Data:

RTECS: CAS# 7732-18-5: ZC0110000 / CAS# 124-68-5:UA5950000 / / CAS# 61791-24-0: KO9275000

 

LD/LC50:CAS# 7732-18-5: LD50= >90 mL/Kg / CAS# 124-68-5: Oral, rat LD50 = 2900 mg/Kg; Oral, mouse LD50 = 2150 mg/Kg / CAS# 61791-24-0: Oral, rat LD50 = 813 mg/Kg

 

• Carcinogenicity: Ingredients not listed as carcinogens by ACGIH, IARC, NIOSH, NTR, or OSHA

Environmental Fate: CAS# 61791-24-0 is readily biodegradable by the closed bottle test.;

Environmental Toxicity: CAS# 61791-24-0: 96 hr. LC50 = 0.39 mg/L for Zebra fish (nominal concentration)

 RCRA Hazard Class (if discarded): CORROSIVE D002 Whatever cannot be saved for recovery or recycling should be managed in an appropriate and approved waste facility. State and local disposal regulations may differ from federal disposal regulations. Empty containers may contain residues. Thoroughly clean empty container, then offer for recycling, reuse or disposal in accordance with federal, state and local requirements.

The actual product pH of 11.8 is below the RCRA Hazard rating of "D002-Corrosive" of 12.5 or higher.

• DOT Proper Shipping Name:Corrosive liquid (contains AMP), NOS, Class 8, UN 1760, PG II
• DOT Hazard Class: (8)
• UN Number: 1760
• Packing Group: II
• DOT Label: Corrosive liquid, N.O.S (contains AMP) Class 8, UN 1760, PG II

• TSCA:(40CFR 710) All chemical ingredients are listed on the TSCA 8(b) inventory. None of the ingredients are on the Health and Safety Reporting List, are under Chemical Test rule, are listed under TSCA Section 12B, or have a SNUR under TSCA
• CERCLA Reportable Quantity: This product does NOT contain ingredients that have Reportable Quantity (RQ) requirements under US 40 CFR 117.302
• SARA TITLE III:

Section 302/304 Extremely Hazardous Substances: None

Section 311 Hazard Categorization: Acute, Chronic, Flammable

Section 313 Toxic Chemicals: None 

• Clean Water Act: This product contains no ingredients that CWA lists on its "Hazardous Substances", "Priority Pollutant" or "Toxic Pollutant" lists.
• Clean Air Act: No ingredients listed as a hazardous air pollutant (HAP). This product does not contain any Class 1 or Class 2 ozone depletors, nor was it made with such chemicals.
• OSHA: None of the chemicals in this formula are considered highly hazardous by OSHA.
• STATE RIGHT-TO-KNOW LISTS: 2-Amino-2- methyl-1-propanol, CAS#124-68-5, representing representing 12.6% of this product IS found on the following RTK lists: Pennsylvania & Massachusetts.  Other ingredients NOT listed on the following RTK lists: California, Connecticut, Florida, Illinois, Louisiana, Maine, Maryland, Massachusetts, Minnesota, New Jersey, New York, Pennsylvania, Rhode Island or Tennessee.
• Not subject to California Proposition 65 labeling requirements
• Canadian WHMIS classification: "E" corrosive & D2B
• Canadian DSL: All ingredients listed on Canada's DSL list. Product is authorized for sale in Canada.
• Canada's Ingredient Disclosure List: 2-Amino-2- methyl-1-propanol, CAS#124-68-5, representing 12.6% of this product ARE listed on the CIDL, but other ingredients are "NOT CONTROLLED". This MSDS has been prepared according to the hazard criteria of the Controlled Products Regulations (CPR) and the MSDS contains all of the information required by the CPR.
• TDG Classification: Corrosive liquid, N.O.S (contains AMP) Class 8, UN 1760, PG II
  

Reason for Revision: Routine Review and Revision

Alken-Murray Corporation provides the information contained herein in good faith, in compliance with the Occupational Safety and Health Act of 1970, but makes no representation as to its comprehensiveness or accuracy. This document is intended only as a guide to the appropriate precautionary handling of the material by a properly trained person using this product. Alken-Murray warrants that this product is of merchantable quality. The implied warranty of fitness for a particular purpose is limited to the extent the products are used for the purpose or uses described on the product's label or in any written instructions or materials distributed to the buyer by Alken-Murray and is hereby disclaimed should buyer use the products in a manner inconsistent with this uses or purposes described therein. In no event shall Alken-Murray be liable for any consequential, exemplary, or incidental damages incurred by buyer even if it has been advised of the possibility of such damages.