ALKEN CLEAR-FLO® 7030
Effective Date: 02/03/2003
|Manufacturer's Name: Alken-Murray Corporation|
|Manufacturer's Address: P.O. Box 400, New Hyde Park, New York 11040|
|T: 540-636-1236 Fax: 540-636-1770|
|Manufacturer's Cage Code: 2A384|
NFPA Hazard Ratings:
0=Minimal, 1=Slight, 2=Moderate, 3=Serious, 4=Severe
|CAS Number:||Not applicable to mixtures|
|Formula ID Codes:||7030|
|Chemical Name||CAS Number||OSHA PEL||ACGIH TLV||% Weight|
|Wheat bran substrate||116469-86-4||NDA||NDA||85 - 90|
|Water||7732-18-5||NDA||NDA||10 - 15|
|Viable bacterial cultures||NA||NDA||NDA||1|
Emergency Overview: Organisms used are non-pathogenic, but can cause infection when in contact with open wounds. These organisms are susceptible to many commonly used antibiotics.
Potential Health Effects:
Flash Point: NA
Flammability Limits: NA
Autoignition temp: NA
Fire Extinguishing Media: Water spray, carbon dioxide, dry chemical
Special Fire-Fighting Information: None
Unusual Fire and Explosion Hazards: None
|For small spills, flush to waste treatment sewer (product is biodegradable). For large spills, contain and collect for reuse. Wear approved respirator for nuisance dust during cleanup.|
|Store in cool dry place. Keep container closed when not in use. Avoid storage of product above 110 degrees F and keep from freezing. Keep out of direct sunlight.|
Environmental Fate: This product is not likely to bioconcentrate and is unlikely to create any negative environmental impact, other than a slight reduction in oxygen concentration at the site of release.
Environmental Toxicity: This formula is safe for aquatic environments.
|RCRA Hazard Class (if discarded): N/A.Wash containers down with water and disinfect with a 1% sodium hypochlorite solution before unregulated disposal.|
..................................Section 302/304 Extremely Hazardous Substances: None
..................................Section 311 Hazard Categorization: Acute, chronic
..................................Section 313 Toxic Chemicals: None
16. Other Information
Reason for Revision: Routine review and revision
Alken-Murray Corporation provides the information contained herein in good faith, in compliance with the Occupational Safety and Health Act of 1970, but makes no representation as to its comprehensiveness or accuracy. This document is intended only as a guide to the appropriate precautionary handling of the material by a properly trained person using this product. Alken-Murray warrants that this product is of merchantable quality. The implied warranty of fitness for a particular purpose is limited to the extent the products are used for the purpose or uses described on the product's label or in any written instructions or materials distributed to the buyer by Alken-Murray and is hereby disclaimed should buyer use the products in a manner inconsistent with this uses or purposes described therein. In no event shall Alken-Murray be liable for any consequential, exemplary, or incidental damages incurred by buyer even if it has been advised of the possibility of such damages.