NFPA Hazard Ratings:

0=Minimal, 1=Slight, 2=Moderate, 3=Serious, 4=Severe

Emergency Overview: The microorganisms used in this product are BioSafety Class 1 microorganisms, as defined by the Centers for Disease Control as unlikely to cause disease in healthy humans or animals. However, persons with compromised immune systems should avoid contact with open wounds and/or breathing dust or mist from manufacturing processes. These organisms are susceptible to many commonly used antibiotics, and Alken-Murray is willing to supply antibiotic sensitivity information to any doctor or import health authority requesting it. Because surfactants are included, primary skin irritation under 29CFR 1910.1200 is considered possible, as is true of many shampoos that contain the same surfactants. Although bacterial cultures included in this product were grown in a sterile aqueous medium containing a variety of nutrients, including corn syrup solids, digests of soybean and/or skim milk, glucose or other sugars, vegetable oils, including olive oil, yeast extract, mineral salts, etc., the concentrations of these residual nutrients are believed to be below levels capable of triggering irritation.

Potential Health Effects:

• Signs and Symptoms of Acute Overexposure: Eye, skin irritation
• Signs and Symptoms of Chronic overexposure: Dermatitis and skin sensitization
• Medical Conditions Generally Aggravated by Exposure: Allergies, dermatitis.
• Ingestion: May result in abdominal pain, nausea and vomiting. Irritation of the mouth, pharynx, esophagus and stomach can develop following ingestion.

• Inhalation: Remove victim to fresh air
• Ingestion: Give victim water or milk to drink to dilute the product. Get medical advice..
• Skin Contact: Remove contaminated clothing and footwear. Wash skin with soap and water. Wash clothing before reuse.
• Eye Contact: Immediately flush eyes with water for 15 minutes. Get medical attention.
• Note to Physician: If patient's immune system is compromised, request antibiotic sensitivity chart from Alken-Murray Corporation by e-mail: msds@alken-murray.com

 Flash Point: NA

Flammability Limits: NA

Autoignition temp: NA

Fire Extinguishing Media: Water spray, carbon dioxide, dry chemical

Special Fire-Fighting Information: None

Unusual Fire and Explosion Hazards: None

• Ventilation System: Good general ventilation is advisable
• Personal Respirators (NIOSH Approved): if needed, use respirator to screen out nuisance dust
• Skin Protection: Long sleeved clothing
• Eye Protection: Safety glasses if mist is formed indoors.
• Other Control Measures: Minimize exposure in accordance with good hygiene practice. Avoid handling which would create large amounts of dust.

• Appearance and Color: Turbid tan liquid.
• Odor: "Wild hyacinth" fragrance added
• Solubility in Water: 99%
• Specific Gravity: 1.121
• Bulk density: NDA
• pH: 7.5 - 8.5
• % volatile by volume @ 21C (70F): Nil
• Boiling Point: 212 degrees F, 100 degrees C
• Melting Point: 32 degrees F
• Vapor Density (Air=1): =water
• Vapor Pressure (mm Hg): =water
• Evaporation Rate (Bu. Acetate=1): =water

• Stability: Product is stable.
• Hazardous Decomposition Products: None
• Hazardous Polymerization: will not occur.
• Incompatibility: Acids, alkalies, other toxic materials may inactivate biological cultures.
• Conditions to Avoid: Incompatible substances

• Toxicological Data: (CFR Title 16, Title 1500.42)

RTECS: CAS# 7732-18-5: ZC0110000/ CAS# 7631-99-4: WC5600000/ CAS# 7783-28-0: TB9375000/ CAS# 56-81-5: MA8050000/ CAS# 1300-72-7: ZE5100000/ CAS# 27176-87-0: DB6600000/ Bacterial cultures: 1003657BA/ CAS 2634-33-5: 1004600BE/ CAS# 1310-73-2: WB4900000/ CAS# 25265-71-8: UB8765000/ CAS# 64-02-8: AH5075000/ CAS# 134-20-3: CB3325000/
LD50/LC50 - Yucca schidigera - Oral toxicity for a 70% solution is > 5000 mg/kg

CAS# 7631-99-4: Oral, rat LD50 IS 4,300 MG/KG / CAS 1310-73-2: skin, rabbit: 500 mg/24H severe; eye rabbit: 50 ug/24H severe.

CAS# 1310-73-2: skin, rabbit: 500 mg/24H severe; eye rabbit: 50 ug/24H severe.

CAS# 27176-87-0: oral, rat LD50 = 650 mg/Kg.

CAS 1300-72-7: oral, rat = 1,000 mg/Kg

CAS# 64-02-8: acute, oral, rat LD50 = 3030 mg/Kg; acute, dermal, rabbit LD50 =5,000 mg/Kg
CAS# 25265-71-8: oral, rat LD50 = 14850 mg/Kg; skin, rabbit, LD50 = > 20 mL/Kg.

CAS 56-81-5: oral, mouse > 4090 mg/kg; skin, rabbit 500 mg mild reaction 24H,
eye, rabbit, mild reaction at 24 H.

Dermal & Eye Irritation Tests for Proprietary "Oxygenated organic/inorganic salts Solution" - sold as ALKEN® 896 BIOSTIMULANT
Acute dermal irritation study New Zealand white rabbits: A 20% solutionm (5 ml "Oxygenated organic/inorganic salts Solution" + 20 mL sterile, distilled water) was applied to intact & abraded skin one one side, with sterile water applied to intact & abraded skin on other side of same animals to serve as controls.
Acute dermal irritation New Zealand white rabbits: PI = 0.0, Toxicity level IV
Acute eye irritation: A 20% solution (5 ml "Oxygenated organic/inorganic salts Solution" + 20 mL sterile, water) was introduced to one eye, while untreated eye was observed as a "control". Eyes were examined and graded at 24, 48 and 72 hours post treatment..
Acute eye irritation, :New Zealand white rabbits: PI=0.0, Toxicity IV
Bacteria in this product: Acute oral toxicity: Rats LD50 = > 5 grams/kg, no toxicity symptoms, no weight loss

Acute dermal toxicity: LD50 = > 5050 mg/Kg

Acute dermal irritation albino rabbits: PI = 0.0, Toxicity level IV

Acute eye irritation: PI=0.0, Toxicity IV
Acute Inhalation, Rats LC50= >2.43 mg/L.

• Carcinogenicity: Not listed by ACGIH, IARC, NIOSH, NTR, or OSHA

• DOT Proper Shipping Name: Not regulated as hazardous by DOT
• DOT Hazard Class: None
• UN/NA Number: None
• Packing Group: None
• DOT Label: The proper shipping name for UNREGULATED SHIPMENT via DOT and TDG is as follows: "Class 55 (Item 048580, sub 3): "Cleaning or washing compound NOI, liquid, in drums or pails". Alken Enz-Odor 2-5XFF Manufacturing Concentrate

• TSCA: (40CFR 710) All chemical ingredients are listed on the TSCA 8(b) inventory. None of the ingredients are on the Health and Safety Reporting List, are under Chemical Test rule, are listed under TSCA Section 12B, or have a SNUR under TSCA
• CERCLA Reportable Quantity: CAS# 27176-57-0 =1,000 lb. Final RQ (454Kg). Since this ingredient represents less than 1% of product, actual weight of spilled product would have to exceed 105,263 lbs (47, 747 Kg) to meet this standard.
• Clean Water Act: This product contains no ingredients that CWA lists on its "Hazardous Substances", "Priority Pollutant" or "Toxic Pollutant" lists.
• Clean Air Act: CAS# 27176-87-0 IS listed on the "hazardous air pollutants" list of CWA. Ingredients of this product are NOT listed as a hazardous air pollutants (HAP) on CWA. This product does not contain any Class 1 or Class 2 ozone depletors, nor was it made with such chemicals.
• SARA TITLE III:

..................................Section 302/304 Extremely Hazardous Substances: None

..................................Section 311 Hazard Categorization: Acute, chronic

..................... Section 313 Toxic Chemicals: This material contains sodium hydroxide (CAS 1310-73-2) which is subject to reporting requirements of Section 313 or Sara Title III and 40 CFR Part 373. 1,000 lb Final RQ (454 Kg). This ingredient represents less than 1% of final product formula, which has a neutral pH, thereby avoiding ALL issues that could lead to the need for a reporting incident. At less than 1% of finished formula, a total weight of 1,000 lbs sodium hydroxide would be included in 100,000 lbs of liquid product with NEUTRAL pH.
OSHA: None of the ingredients is listed on the OSHA "Highly Hazardous" List.

• STATE RIGHT-TO-KNOW LAWS:Dipropylene glycol (< 1%), CAS# 25265-71-8 IS found on the Pennsylvania RTK list, while Glycerine (2.5%), CAS# 56-81-5 & CAS# 27176-87-0 (<1%) ARE found on the following RTK lists: Pennsylvania, Minnesota & Massachussetts. Other ingredients NOT listed on California, Connecticut, Florida, Illinois, Louisiana, Massachusetts, New Jersey, New York, Pennsylvania, or Rhode Island.
• Not subject to California Proposition 65 labeling requirements
• WGK (Water Danger/Protection): CAS# 7631-99-4:1, CAS# 7783-28-0:1, 56-81-5:0, 25265-71-8:1
• Canadian WHMIS Classification: Class D2B. (Other toxic effects - for nitrate, surfactants & imported LIVE microbial cultures). CAS# 27176-87-0, 1310-73-2 & 64-02-8 (combined at < 1%) normally add a "Class E" to products containing them, but the neutral pH of THIS product exempts it from this addition.
• Canadian DSL::All ingredients listed. Product Approved for sale in Canada
• Canada's Ingredient Disclosure List: Sodium nitrate, CAS# 7631-99-4, comprising ~ 30% of this product, CAS# 27176-87-0, comprising < 1% of this product, Sodium hydroxide, CAS 1310-73-2, comprising < 1% of this product ARE listed on the CIDL, but other ingredients are "NOT CONTROLLED". . This MSDS has been prepared according to the hazard criteria of the Controlled Products Regulations (CPR) and the MSDS contains all of the information required by the CPR.
• TDG Classification: Transport as non-hazardous

USA Freight Paired with Matching IHT for Alken Enz-Odor 2 - Two Options:

1. Domestic leg of trip: Class 55 (Item 048580, sub 3), Cleaning & Washing Compound, N.O.I liquid, in drums or pails.
   IHT code 3402.90.5000 "Surface active, washing and cleaning preparations, NESOI, put up for retail sale" Must resell at RETAIL in destination country to use this designation
2. Domestic leg of trip: Class 60 (item 20400) "Bacteria, sewage or industrial waste treating, in dry or liquid carrier, with or without enzymes in bulk, bags, barrels or pails."
   IHT code: 3002.90.5150 "Bacterial cultures for Environmental Defense". This is the preferred pairing of DOT and IHT codes for most recipient countries, but check your own import regulations first.
   
   
   

Reason for Revision: Routine review & revision

Alken-Murray Corporation provides the information contained herein in good faith, in compliance with the Occupational Safety and Health Act of 1970, but makes no representation as to its comprehensiveness or accuracy. This document is intended only as a guide to the appropriate precautionary handling of the material by a properly trained person using this product. Alken-Murray warrants that this product is of merchantable quality. The implied warranty of fitness for a particular purpose is limited to the extent the products are used for the purpose or uses described on the product's label or in any written instructions or materials distributed to the buyer by Alken-Murray and is hereby disclaimed should buyer use the products in a manner inconsistent with this uses or purposes described therein. In no event shall Alken-Murray be liable for any consequential, exemplary, or incidental damages incurred by buyer even if it has been advised of the possibility of such damages.