All ingredients on Canadian
DSL and USA TSCA lists
1. Product Identification
Not applicable to mixtures
Formula ID Codes:
2. Composition/Information on Ingredients
Ingredients not precisely
identified are proprietary and/or non-hazardous. All chemical ingredients
appear on the EPA TSCA inventory.
Ethanediamine, polymer with (chloromethyl)
oxirane and N-methylmethanamine
Light, Low Odor Petroleum hydrotreated
3. Hazards Identification
Emergency Overview: Caution: Irritant to eyes, skin. .
Signs and Symptoms of
Acute Overexposure: Mild
eye, skin irritation.
Signs and Symptoms of
Chronic overexposure: Discomfort,
irritation of eyes and skin with swelling and possible reddening of or
visible rash on skin.
Medical Conditions Generally
Aggravated by Exposure:
Existing cuts, rashes, allergies or other sensitive areas would possibility
be aggravated by exposure.
Ingestion: Ingestion may result in abdominal pain,
nausea, and vomiting.
4. First Aid Measures
Inhalation: Remove victim to fresh air
Ingestion: Give victim water or milk to drink to dilute
the product. Get medical advice..
Skin Contact: Remove contaminated clothing and footwear.
Wash skin with soap and water. Wash clothing before reuse.
Eye Contact: Immediately flush eyes with water for
15 minutes. Get medical attention.
Note to Physician: None
5. Fire Fighting Measures
Flash Point: > 200 degrees F (PMCC)
Flammability Limits: NDA
Autoignition temp: NDA
Fire Extinguishing Media:
Not expected to burn
unless heated to dryness. Residue may ignite. Use water, foam, carbon dioxide,
dry chemical, Halon 1211 to extinguish
Special Fire-Fighting Information:
Spilled chemical creates
extremely slippery conditions, especially in contact with water. Use caution.
Respiratory and eye protection are reqyired. Petroleum component is combustible,
if separated from other ingredients. Vapors/fumes will ignite.
Unusual Fire and Explosion
Hazards: None known
6. Accidental Release Measures
Contain and collect, using a suitable
absorbent if needed (sand, earth or vermiculite). Flush residuals to drain
with water for normal biological water treatment. Place collected material
into suitable containers for disposal. Can usually be disposed of my approved
metered release to WWTP or other approved disposal. Observe local, federal
and state disposal regulations. Several washes and/or the use of detergents
may be necessary to completely clean any spills.
7. Handling and Storage
Handle as an irritant. Do not
get into eyes. Avoid prolonged/repeated skin contact. Do not inhale vapors/mists.
Do not ingest. Store away from sources of ignition. Spilled product creates
very slippery conditions, especially in contact with water. Avoid freezing
which may cause separation and increases in viscosity. Do not store above
85 deg. F for long periods of time. Several washes and/or the use of detergents
may be necessary to completely clean any spills
8. Exposure Controls/ Personal Protection
Ventilation System: Good general ventilation is advisable.
Local exhaust desired.
Personal Respirators (NIOSH
Approved): None required
for normal use and processes. if needed, use respirator to filter out mists/vapors.
Skin Protection: Long sleeved clothing, impervious rubber
or neoprene gloves and protective apron.
Eye Protection: Safety glasses or goggles
Other Control Measures:
in accordance with good hygiene practice. Avoid handling which would create
large amounts of mists/vapors.
9. Physical and Chemical Properties
Appearance and Color:
Amber colored, viscous
Eye & skin irritant. May aggravate existing medical conditions,
such as rashes, allergies or other sensitive areas. Symptoms may include
reddening, swelling of effected areas with possible itching, burning or
RTECS: CAS# 42751-79-1:1008553DE/ CAS 64742-47-8: OA5504000
Carcinogenicity: Not listed by ACGIH, IARC, NIOSH, NTR,
12. Ecological Information
Environmental Toxicity: NDA
Environmental Fate: Persistence in the environment unknown.
Alken Solutions C189K COD (Chemical Oxygen Demand) = 150,000
Bioaccumulation (Kow <10)
13. Disposal Considerations
RCRA Hazard Class (if
discarded): Neat, unused
product is not considered a hazardous waste, according to RCRA regulations
40 CFR 261. . For proper disposal of used materials, an assessment must
be completed to determine the proper waste management options permissible
under applicable rules, regulations and/or laws governing client's location.
Use until less than 1 inch remains in the container, triple rinse with clean
water, and pour rinse water to sewer. Then remove or deface product label
to avoid confusion if pail or drum is later refilled. Clean, empty containers
should be recycled or disposed of through an approved waste management facility.
14. Transportation Information
DOT Proper Shipping Name: Not regulated as hazardous by DOT
DOT Hazard Class: None
DOT Label: Class 60:(NMFC item #4612, LTL) "adhesives,
adjuvents, spreaders, sliders, liquid, in pails or drums" Alken Solutions
C189K cationic polyquaternary polymer liquid
15. Regulatory Information
TSCA: : (40CFR 710) All chemical ingredients
are listed on the TSCA 8(b) inventory. None of the ingredients are on the
Health and Safety Reporting List, are under Chemical Test rule, are listed
under TSCA Section 12B, or have a SNUR under TSCA CERCLA Reportable Quantity: This product does NOT contain
ingredients that have Reportable Quantity (RQ) requirements under US 40
Clean Water Act: None of the chemicals in this formula are
listed as Priority Pollutants under CWA.
Clean Air Act : Ingredients not listed as hazardous pollutants
under CAA. This product does not contain any Class 1 or Class 2 ozone depletors,
nor was it made with such chemicals.
OSHA: None of the ingredients are considered Extremely
Hazardous by OSHA.
STATE RIGHT-TO-KNOW LAWS:. Ingredients not listed on California,
Connecticut, Florida, Illinois, Louisiana, Massachusetts, New Jersey, New
York, Pennsylvania, or Rhode Island.
Not subject to California Proposition
65 labeling requirements
Canadian WHMIS Classification:
CAS 64742-47-8: B3. Combustible
Liquid, but flash point of formulated product has a flash pint above flammable-combustible
limit for Canada
Canadian DSL: all ingredients listed and compliant
Canada's Ingredient Disclosure
List:Light hydrotreated kerosine solvent CAS#
64742-47-8, comprising 25% of this product IS listed on the CIDL, but other ingredients are "NOT CONTROLLED".
This MSDS has been prepared according to the hazard criteria of the Controlled
Products Regulations (CPR) and the MSDS contains all of the information
required by the CPR.
TDG Classification: Not regulated as hazardous by Canadian
provides the information contained herein in good faith, in compliance with
the Occupational Safety and Health Act of 1970, but makes no representation
as to its comprehensiveness or accuracy. This document is intended only
as a guide to the appropriate precautionary handling of the material by
a properly trained person using this product. Alken-Murray warrants that
this product is of merchantable quality. The implied warranty of fitness
for a particular purpose is limited to the extent the products are used
for the purpose or uses described on the product's label or in any written
instructions or materials distributed to the buyer by Alken-Murray and is
hereby disclaimed should buyer use the products in a manner inconsistent
with this uses or purposes described therein. In no event shall Alken-Murray
be liable for any consequential, exemplary, or incidental damages incurred
by buyer even if it has been advised of the possibility of such damages.